ACME PCB Assembly has been providing high-quality Electronic Manufacturing Services (EMS) in the Los Angeles area since 1993, and BGA assembly since 1995.
Responsive to customer requirements
We are a mid-sized EMS company—a good match for production runs that range from prototype to 20,000 units. Being a mid-sized contract manufacturer, we are more flexible and responsive to production requirements than the larger assembly houses. We continually strive to have the best equipment to provide the highest quality PCB assembly services. In addition, when it comes to pricing we are very competitive.
Quality assurance
ACME PCB Assemblyis ISO 9001:2015 certified and we have an in-house IPC A-610 certified trainer. We are very proud about our quality certification. It demonstrates that we adhere to procedures that can be measured to meet or exceed the customer’s quality expectations.
Design services offered:
- Electronics R & D
- PCB design
- PCB layout
- PCB fabrication
- PCB rework
Assembly services offered:
- Thru-hole PCB assembly
- SMT PCB assembly
- Prototype PCB assembly
- Electronic engineering
- Turnkey assembly
- Fine-pitch IC soldering
- Ball-Grid array PCB assembly
Other electronic manufacturing services offered:
- Wire stripping
- Wire harness
- Cable assembly
- Conformal coating
- Potting
SMT ASSEMBLY
SMT, or surface-mount technology, is a method where the components are mounted or placed onto the surface of a PCB, or printed circuit board. There are some components that are unsuitable for SMT assembly, such as large transformers and heat-sinked power semiconductors, but other processes can handle them. Employing this technology speeds up the production process but the catch is the risk of defects due to component miniaturization and denser packing of boards. SMT assembly is also highly dependent on automation and medium to high-scale production. Here at ACME PCB, we can work with components as small as 01005 and assemble high quantity boards to low quantity boards.
SMT assembly can be done on both sides of a PCB. The SMT process starts off with a screen-printing process that applies solder paste onto all the solder pads. These solder pads are where the components are placed. The pads are normally flat and made from either tin-lead, silver, or gold-plated copper. After the board is pasted, it is placed onto a conveyor belt and sent to a pick-and-place machine. These components are sometimes in static free trays or plastic tubes.
The last step in the SMT assembly process is the reflow soldering oven. The solder particles in the solder paste are melted. This makes the component bond to the solder pads. At ACME PCB, we make sure to check each board for defects and errors before sending them to the reflow oven. After the heating process, the boards are put into our in-line washer to remove any traces of white residue, dirt, and other contaminants. If any leadless parts are used, they are inspected using our X-ray machine to ensure solder joint quality.
For business inquiries or quoting services, call ACME PCB Assembly at (310) 715-1898. you can also visit our other site at: http://boardassembly.com.